Your search for die casting resulted in 13 matches...
The article presents the results of research on the selection of optimum technological parameters of the hot-chamber die casting machine operation to make castings in AM50 magnesium alloy, coated next with the deco...
more >>
The article presents the results of investigations of a technology for fabrication of decorative and protective chromate coatings on die castings made from AZ91 (MgAl9Zn1) magnesium alloy. As a result of the investigat...
more >>
The manufacturing of cast iron castings by pressure die casting method, evaluation of castings microstructure and process analysis were the purpose of the experiments. White cast iron castings were fabricated and then these castings were annealed....
more >>
The paper presents the possibility of obtaining highquality silumin castings with enhanced mechanical properties. It ensures the effective use of the multipoint water mist cooling system which is managed by a dedicated computer program....
more >>
Recycling of magnesium alloys is a complex issue not only because of their high reactivity and flammability even below melting temperature, but primarily because of a lack of equipment and experience in foundries. Nonetheless the environmental fac...
more >>
The effect of tungsten on the solidification process, microstructure and mechanical properties of silumin 226 under the conditions close to equilibrium during pressure die casting was discussed. An increase in both mechanical and plastic propertie...
more >>
Computer programs are now a common tool aiding the engineer’s work on structure design. The design of foundry moulds used in the pressure die casting process, based on the casting design and effectively utilising the ability to create 3D ima...
more >>
The article presents research results of the process foundry return influence in the AZ91 alloy charge on the change in the structure of castings made by the high-pressure casting method, with special consideration of the formation of non-metallic...
more >>
The die casting method is based on casting into permanent metal moulds, which makes it possible to obtain a large amount of casts with practically identical shapes. Compared to the technology of sand mould casting, this method has many advantages....
more >>
The paper presents the results of the study of Al-Si alloys with a vanadium addition used in pressure casting. The hypoeutectic Al-Si alloy grade EN AC-46000 was applied as the initial alloy. The master alloy AlV10 was introduced into the initial ...
more >>
The article presents the results of investigations into castings made of four aluminum alloys produced with the use of squeeze casting technology.The investigations used the following alloys: EN AW 7022 (AlZn5Mg3Cu) and its modification with...
more >>
The paper presents the results of studies of hypoeutectic silumin with a chromium addition used for pressure casting. A silumin with the composition similar to that of EN AC-46000 was used as the initial one. In order to introduce chromi...
more >>
The article presents the history and current state of the technology of external pressure casting in the case of High Pressure Die Casting (HPDC) and Squeeze Casting (SC). The similarities and differences between the two technologies and the commo...
more >>
| 
